LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2006 >> Focus ZX5 SE, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 741 (Fuel System - General Information - F-150 & Mark LT) >> General Procedures >> Vapor Tube Fittings >> Connect

Vapor Tube Fittings: Connect

WARNING: This page is about a different car, the 2007 Lincoln Mark LT and 2007 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
    CAUTION: Make sure the vapor tube fitting clicks into place when installing the tube. To make sure that the vapor tube fitting is fully seated, pull on the tube.
    NOTE: Apply clean engine oil to the end of the tube or fitting before connecting.
  1. Connect the vapor tube fitting.
    2. Fig 1: Connecting Quick Connect Fitting
    GF0004215Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals