LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2006 >> Focus ZX5 SE, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 739 (Engine Emission Control System - F-150 & Mark LT) >> Removal And Installation >> Positive Crankcase Ventilation (PCV) Heater Element - 5.4L (3V) >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2007 Lincoln Mark LT and 2007 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES article.
  2. Disconnect the positive crankcase ventilation (PCV) heater element tube quick connect coupling. For additional information, refer to FUEL SYSTEM - GENERAL INFORMATION article.
  3. Disconnect the PCV heater element electrical connector.
  4. Remove the bolts and the PCV heater element. Remove and discard the O-ring seal.
    • To install, tighten to 6 N.m (53 lb-in).
  5. To install, reverse the removal procedure.
    • Install a new O-ring seal on the PCV heater element. Lubricate the O-ring seal with clean engine oil.
scientia non olet · About LEMON Manuals