LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2006 >> Focus ZX5 SE, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 728 (Supplemental Inflatable Restraint System - F-150 & Mark LT) >> Removal And Installation >> Passenger Air Bag Module >> Installation

Passenger Air Bag Module: Installation

WARNING: This page is about a different car, the 2007 Lincoln Mark LT and 2007 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. Connect the 2 passenger air bag module electrical connectors.
    2. NOTE: Make sure the J-clips are in place before positioning the passenger air bag module to the instrument panel.
  2. Position the passenger air bag module into the instrument panel.
    • Angle the rear of the passenger air bag module deployment door so the tabs engage to the instrument panel.
    • Position the passenger air bag module into place and push down on the deployment door, engaging the remaining tabs.
    3. Fig 1: Positioning Passenger Air Bag Module Into Instrument Panel
    GF0002227Courtesy of FORD MOTOR CO.
  3. Install the RH defrost grille.
  4. Install the 2 pin-type retainers that retain the passenger air bag module deployment door to the instrument panel (if equipped).
  5. Install the passenger air bag module bolts.
    • To install, tighten to 9 Nm (80 lb-in).
  6. Close the glove compartment.
  7. Repower the SRS. For additional information, refer to Supplemental Restraint System (SRS) Depowering and Repowering  in the General Procedures portion of this section.
scientia non olet · About LEMON Manuals