LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2006 >> Focus ZX5 SE, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 724 (MULTIFUNCTION Electronic Module - F-150 & Mark LT) >> Removal And Installation >> Vehicle Security Module (VSM) - Regular Cab >> Removal

Vehicle Security Module (VSM) - Regular Cab: Removal

WARNING: This page is about a different car, the 2007 Lincoln Mark LT and 2007 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Electronic modules are sensitive to static electrical charges. If exposed to these charges, damage may result.
NOTE: Prior to the removal of the module, it is necessary to upload the module configuration information to a scan tool. This information must be downloaded into the new VSM after installation. For additional information, refer to MODULE CONFIGURATION article, to carry out programmable module installation (PMI).
NOTE: For vehicle security module (VSM) programming, refer to steps a-d below.
  1. Turn the headlamp switch to the OFF position.
  2. Turn the ignition key to the ON position.
  3. Open the drivers door.
  4. Unlock the doors using the interior door lock control switch.
    NOTE: The TPMS functionality is integral to the VSM.
    NOTE: A new VSM is delivered into a manufacturing mode with 6 pre-set DTCs. These DTCs require that successful configuration of the VSM occurs, then successful TPMS sensor training occurs, then a successful self-test occurs, including clearing of DTCs. This is required in order to clear the 6 manufacturing mode DTCs. They are as follows:
    • B2477 (Module Configuration Failure)
    • B2868 (Left Front Tire Pressure Sensor Fault)
    • B2869 (Right Front Tire Pressure Sensor Fault)
    • B2870 (Right Rear Tire Pressure Sensor Fault)
    • B2871 (Left Rear Tire Pressure Sensor Fault)
    • C2780 (ECU in Manufacturer Sub-state)
  1. Upload the module configuration information from the VSM into the scan tool. For additional information, refer to MODULE CONFIGURATION article.
  2. Turn the key to the OFF position.
  3. Remove the LH B-pillar trim panel. For additional information, refer to INTERIOR TRIM AND ORNAMENTATION article.
  4. Disconnect the 3 (built before 12/2006) or 2 (built after 12/2006) VSM electrical connectors.
    5. NOTE: If it is necessary to install new VSM mounting screw J-clips, they are available using part number W520822.
  5. Remove the 2 screws and the VSM.
scientia non olet · About LEMON Manuals