Seat - Front: Installation
WARNING: This page is about a different car, the 2007 Lincoln Mark LT and 2007 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
- Position the seat in the vehicle.
- Connect the electrical connector(s).
- Install the 2 front seat track-to-floor rear bolts.
- Tighten the rear seat bolts to 48 Nm (35 lb-ft) in the following sequence:
- Rear outboard bolt.
- Rear inboard bolt.
- Tighten the rear seat bolts to 48 Nm (35 lb-ft) in the following sequence:
- Repower the SRS. For additional information, refer to Supplemental Restraint System (SRS) Depowering and Repowering in the General Procedures portion of SUPPLEMENTAL RESTRAINT SYSTEM article.
- Move the seat fully rearward.
- Install the 2 front seat track-to-floor bolts.
- Tighten to 48 Nm (35 lb-ft).
NOTE:
Additional component connectors may exist due to vehicle options.