All seats
WARNING: This page is about a different car, the 2007 Lincoln Mark LT and 2007 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the 20 percent seat. For additional information, refer to Seat - Front, 20 Percent in this article.
- Remove the LH side shield pin-type retainer, screw and shield.
- Remove the RH upper side shield screw and shield.
- Remove the RH lower side shield screw and shield.
- Remove the safety belt buckle or safety belt mini-buckle bolt and the buckle/mini-buckle on the LH side.
- To install, tighten to 55 Nm (41 lb-ft).
- Remove the lap safety belt or safety belt buckle bolt and the safety belt/buckle on the RH side.
- To install, tighten to 55 Nm (41 lb-ft).
- Remove the LH backrest bracket pivot bolt and pivot bolt bushing.
- To install, tighten to 35 Nm (26 lb-ft).
- Remove the 2 RH upper adjustable backrest bracket bolts and the adjustable backrest.
- To install, tighten to 35 Nm (26 lb-ft).
- Remove the RH lower adjustable backrest bracket screw, 2 bolts and the adjustable backrest bracket.
- Remove the LH lower backrest pivot bracket screw, 2 bolts and the backrest pivot bracket.
- To assemble, reverse the disassembly procedure.