Removal And Installation
WARNING: This page is about a different car, the 2007 Lincoln Mark LT and 2007 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
- Lower the glove compartment.
- Press the side tabs and release the glove compartment.
- Disconnect the antenna lead-in cable from the antenna cable.
- Push the antenna cable end and the grommet through the side cowl.
- Remove the antenna mast.
- Remove the antenna base cap.
- Remove the RH front fender splash shield. For additional information, refer to FRONT END BODY PANELS article.
- Remove the 3 screws and the antenna base and cable assembly.
- To install, reverse the removal procedure.
NOTE:
A new antenna base cap must be installed.