Removal And Installation
WARNING: This page is about a different car, the 2007 Lincoln Mark LT and 2007 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
- Using a suitable suction device, remove the power steering fluid from the fluid reservoir.
- Remove the 3 power steering fluid reservoir bolts.
- To install, tighten to 11 N.m (8 lb-ft).
- Release the clamp and disconnect the power steering pump supply hose.
- Release the clamp and disconnect the return hose.
- Remove the power steering fluid reservoir.
- To install, reverse the removal procedure.
- Fill the power steering system. For additional information, refer to STEERING SYSTEM - GENERAL INFORMATION article.
CAUTION:
While repairing the power steering system, care should be taken to prevent the entry of foreign materials or failure of the power steering components may result.