LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2006 >> Focus ZX5 SE, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 703 (Engine - 4.2L - F-150) >> In-Vehicle Servicing >> Valve Cover - RH >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2007 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the ignition coil. For additional information, refer to ENGINE IGNITION - 4.2L article.
  2. Disconnect the positive crankcase ventilation (PCV) valve hose and electrical connector.
    • Detach the wiring harness retainer from the valve cover stud bolt.
  3. Remove the nuts and the engine lifting eye.
    • To install, tighten to 25 Nm (18 lb-ft).
  4. Detach the spark plug wire retainers.
  5. Remove the bolt and position the radio interference capacitor aside.
    • To install, tighten to 10 Nm (89 lb-in).
  6. Remove the bolts, the stud bolts and the RH valve cover.
    • To install, tighten to 10 Nm (89 lb-in).
  7. Remove and discard the RH valve cover gasket.
  8. To install, reverse the removal procedure.
    • Install a new RH valve cover gasket.
scientia non olet · About LEMON Manuals