LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2006 >> Focus ZX5 SE, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 702 (Electronic Engine Control System - F-150 & Mark LT) >> Removal And Installation >> Powertrain Control Module (PCM) >> Installation

Powertrain Control Module (PCM): Installation

WARNING: This page is about a different car, the 2007 Lincoln Mark LT and 2007 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. If necessary, install the PCM bracket and the bolts.
    • Tighten to 10 Nm (89 lb-in).
  2. Install the PCM and the bolts.
    • Tighten to 7 Nm (62 lb-in).
  3. Connect the PCM electrical connectors.
  4. Restore the module configuration. Carry out the module configuration restore steps of the Programmable Module Installation procedure. For additional information, refer to MODULE CONFIGURATION article.
  5. Reprogram the passive anti-theft system (PATS). Carry out the Key Programming Using Two Programmed Keys procedure. For additional information, refer to ANTI-THEFT article.
scientia non olet · About LEMON Manuals