Crankshaft Position (CKP) Sensor - 4.2L
WARNING: This page is about a different car, the 2007 Lincoln Mark LT and 2007 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
| Item | Part Number | Description |
|---|---|---|
| 1 | 14A464 | Crankshaft position (CKP) sensor electrical connector |
| 2 | W705398 | CKP sensor bolts (2 required) |
| 3 | 6C315 | CKP sensor |
- With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING article.
- Disconnect the crankshaft position (CKP) sensor electrical connector.
- Remove the bolts and the CKP sensor.
- To install, tighten to 6 Nm (53 lb-in).
- To install, reverse the removal procedure.