Fuel Pump Driver Module (FPDM)
WARNING: This page is about a different car, the 2007 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
| Item | Part Number | Description |
|---|---|---|
| 1 | 14A464 | Fuel pump driver module (FPDM) electrical connector (part of 14405) |
| 2 | W706644-S | FPDM bolt (2 required) |
| 3 | 9D373 | FPDM |
- With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING article.
- Disconnect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES article.
- Disconnect the FPDM electrical connector.
- Remove the FPDM bolts and the FPDM.
- To install, tighten to 10 Nm (89 lb-in).
- To install, reverse the removal procedure.
NOTE:
The fuel pump driver module (FPDM) is located above the spare tire.