6b. Power Balance Test: Purpose:
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2007 Ford RV Cutaway, 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Econoline. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Before carrying out the Power Balance test, allow the engine to stabilize at the temperature necessary to recreate the symptom. Access the PCM and record the freeze frame data. The freeze frame data contains information which can be used to recreate original conditions that caused the symptom. Refer to FREEZE FRAME DATA
for more information.
NOTE:
The contributing power cylinders that immediately follow the non-contributing power cylinders in the firing order may be affected. The affected power cylinders may not be able to fully recover the crankshaft speed, causing them to display below average contributing power cylinders and to be incorrectly identified as the non-contributing power cylinder. Therefore only the cylinders that deviate the most from the average should be identified as the non-contributing power cylinder. Single or inconsistent non-contributing power cylinder traces may be caused by a natural variation in the crankshaft speed and should be ignored.
The purpose of this test is to determine if the injector coils and spool valves are operating correctly by observing individual cylinder contribution while running the Power Balance test.
Power Balance Test
NOTE:
Disregard any DTCs set as a result of the Power Balance test.
- Use the scan tool to carry out the Power Balance test.
- Monitor individual cylinder contribution and record the consistently non-contributing power cylinders.
- Verify operation of bank 1 and bank 2 check valves. Check valve verification is a part of the recommended procedure.
- If the operational bank cylinders operate erratic, install a new check valve.
| Non - Contributing Power Cylinders |