LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2006 >> Focus ZX5 SE, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 668 (Engine Controls - Powertrain DTC Charts And Descriptions (Except Diesel & Hybrid)) >> DTC Diagnosis >> P0605 - Internal Control Module Read Only Memory (ROM) Error

P0605 - Internal Control Module Read Only Memory (ROM) Error

WARNING: This page does not describe the selected car, but rather 32 other vehicles, including the 2007 Mercury Mountaineer, 2007 Mercury Monterey, 2007 Mercury Montego, 2007 Mercury Milan, and 2007 Mercury Mariner. However, it is still accessible from the selected car via links, so may be relevant.
P0605 - INTERNAL CONTROL MODULE READ ONLY MEMORY (ROM) ERROR

Description:  The powertrain control module (PCM) ROM has been corrupted.
Possible Causes: 
  • An attempt was made to change the calibration
  • Module programming error
  • Damaged PCM
Diagnostic Aids:   
Application  Key On Engine Off  Key On Engine Running  Continuous Memory 
All Reprogram or update the calibration. Reprogram the vehicle identification VID block (use as built data). Check for other DTCs or drive symptoms for further action. Make sure to check for aftermarket performance products before installing a new powertrain control module (PCM). If it is necessary to install a new PCM, refer toFLASH ELECTRICALLY ERASABLE PROGRAMMABLE READ ONLY MEMORY (EEPROM) .
scientia non olet · About LEMON Manuals