P0538 - A/C Evaporator Temperature Sensor Circuit High
WARNING: This page does not describe the selected car, but rather 32 other vehicles, including the 2007 Mercury Mountaineer, 2007 Mercury Monterey, 2007 Mercury Montego, 2007 Mercury Milan, and 2007 Mercury Mariner. However, it is still accessible from the selected car via links, so may be relevant.
P0538 - A/C EVAPORATOR TEMPERATURE SENSOR CIRCUIT HIGH
| Description: | Indicates the ACET signal input was greater than the self-test maximum. The self-test maximum is 4.5 volts. | |||
| Possible Causes: |
|
|||
| Diagnostic Aids: | The powertrain control module (PCM) sources a low current 5 volts on the ACET circuit (this voltage can be measured with the sensor disconnected). As the A/C evaporator air temperature changes, the ACET circuit resistance to SIG RTN (ground) changes (which changes the voltage the PCM detects). When the ACET signal is detected above the self-test maximum, check for open circuits (ACET or SIG RTN), which would cause the voltage to remain high. Although not as probable, also check for a short to voltage (VREF). | |||
| Application | Key On Engine Off | Key On Engine Running | Continuous Memory | |
| All | refer to PINPOINT TEST DJ . | |||