LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2006 >> Focus ZX5 SE, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 651 (Automatic Transaxle/Transmission - FNR5) >> In-Vehicle Repair >> Output Shaft Speed (OSS) Sensor >> Installation

Output Shaft Speed (OSS) Sensor: Installation

WARNING: This page is about a different car, the 2006 Mercury Milan and 2006 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: Apply a light coat of petroleum jelly to the O-ring before installation.
  1. Install the OSS sensor.
    • Tighten to 10 Nm (89 lb-in).
    • Connect the electrical connector.
      Fig 1: Locating OSS Sensor
      G04681813Courtesy of FORD MOTOR CO.
  2. Check the transmission fluid level and add automatic transmission fluid as necessary.
    Fig 2: Locating Transmission Fluid Level Mark
    G04681814Courtesy of FORD MOTOR CO.
  3. Start the engine and move the transaxle range selector lever through all gear positions.
scientia non olet · About LEMON Manuals