LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2006 >> Focus ZX5 SE, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 641 (Handles, Locks, Latches And Entry Systems) >> Removal And Installation >> Hood Latch Release Handle >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2006 Mercury Milan, 2006 Lincoln Zephyr, and 2006 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the hood latch. For additional information, refer to HOOD LATCH .
  2. Remove the LH fender splash shield. For additional information, refer to FRONT END BODY PANELS .
  3. Release the 2 hood latch release cable locators from the radiator grille opening panel reinforcement.
  4. Disconnect the hood latch release cable from the LH fender opening, open the 2 hood latch release cable locators and position the cable aside.
  5. Release the hood latch release cable locator from the wiring harness.
  6. Remove the 2 hood latch release handle screws.
    7. NOTE: The hood latch release handle and cable assembly must be pulled through the dash panel into the passenger compartment.
  7. Remove the hood latch release handle and cable assembly.
  8. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals