Removal and Installation
WARNING: This page is about a different car, the 2006 Mercury Milan, 2006 Lincoln Zephyr, and 2006 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
- Fully release the 2 latches and slightly raise the rear seat cushion front edge to disengage from the floor.
- Push the rear seat cushion slightly rearward to disengage the rear edge of the cushion from the rear retainers and remove.
- To install, position the rear seat cushion frame wire over the rear retainers.
- To install, reverse the removal procedure.
- Make sure the safety belts and buckles are accessible to the occupants after installation.
CAUTION:
Do not force the latches or cushion to release. Applying excessive force to release the rear seat cushion latches can damage them.
NOTE:
Make sure the 2 rear cushion latches are fully disengaged before raising the seat cushion to avoid damaging the latches.