LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2006 >> Focus ZX5 SE, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 637 (Seating) >> Removal And Installation >> Seat Backrest Latch - Rear >> Installation

Seat Backrest Latch - Rear: Installation

WARNING: This page is about a different car, the 2006 Mercury Milan, 2006 Lincoln Zephyr, and 2006 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the backrest latch to the 2 studs.
  2. Install the 2 latch nuts and hand tighten.
  3. Attach the release cable to the latch.
  4. Route the release cable, position the release handle and bracket to the 2 studs and install the 2 nuts.
    • To install, tighten to 12 Nm (9 lb-ft).
    1. Install the 2 release cable pin-type retainers.
    • Position the trim and install the pin-type retainer.
  5. Adjust the latch position as necessary for good backrest fit and latch closure when upright.
    • Tighten to 48 Nm (35 lb-ft).
      Fig 1: Adjusting Latch Position
      G04683517Courtesy of FORD MOTOR CO.
  6. Install the parcel shelf. For additional information, refer to INTERIOR TRIM AND ORNAMENTATION .
    • Verify the safety belt retractor operates without excessive effort or binding.
scientia non olet · About LEMON Manuals