LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2006 >> Focus ZX5 SE, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 62 (Automatic Transmission -- F250-F550 Super Duty) >> In-Vehicle Repair >> Internal Harness Service >> Installation

Internal Harness Service: Installation

WARNING: This page is about a different car, the 2005 Ford Pickup, 2005 Ford F550 Super Duty, 2005 Ford F450 Super Duty, and 2005 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Push the bulkhead connector through the transmission solenoid body, twist it to lock it in place.
  2. Connect the internal wiring harness.
    1. Install the two screws.
    2. Connect the transmission fluid temperature sensor electrical connector.
    3. Connect the solenoid electrical connectors.
      Fig 1: Connecting Solenoid Electrical Connectors
      G03889119Courtesy of FORD MOTOR CO.
    3. NOTE: The O-ring must be installed in the top slot.
    Fig 2: Installing Solenoid Body Bulkhead Connector O-Ring
    G03889120Courtesy of FORD MOTOR CO.
  3. Install a new solenoid body bulkhead connector O-ring.
  4. Install the solenoid body.
scientia non olet · About LEMON Manuals