LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2006 >> Focus ZX5 SE, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 62 (Automatic Transmission -- F250-F550 Super Duty) >> Disassembly And Assembly Of Subassemblies >> Solenoid Body >> Assembly

Solenoid Body: Assembly

WARNING: This page is about a different car, the 2005 Ford Pickup, 2005 Ford F550 Super Duty, 2005 Ford F450 Super Duty, and 2005 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install a new gasket and the backing plate.
    Fig 1: Installing Gasket And Backing Plate
    G03889351Courtesy of FORD MOTOR CO.
  2. Install a new filter screen gasket.
    Fig 2: Installing Filter Screen Gasket
    G03889349Courtesy of FORD MOTOR CO.
    3. NOTE: Tighten the bolts in a crisscross pattern to prevent the gasket from becoming distorted.
    Fig 3: Assembling Top And Bottom Halves Of Solenoid Body
    G03889353Courtesy of FORD MOTOR CO.
  3. Assemble the top and bottom halves of the solenoid body.
  4. Install the TFT sensor.
    Fig 4: Installing TFT Sensor
    G03889347Courtesy of FORD MOTOR CO.
  5. Install the shift solenoids with the E-clips.
    Fig 5: Installing Shift Solenoids With E-Clips
    G03889346Courtesy of FORD MOTOR CO.
  6. Install a new O-ring on the solenoid body electrical connector in the uppermost groove.
    Fig 6: Locating Solenoid Body Electrical Connector O-Ring Seal
    G03889078Courtesy of FORD MOTOR CO.
  7. Install the solenoid body harness and connect the connectors.
    Fig 7: Installing Solenoid Body Harness And Connecting Connectors
    G03889345Courtesy of FORD MOTOR CO.
  8. Install the manual valve.
    Fig 8: Installing Manual Valve
    G03889343Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals