LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2006 >> Focus ZX5 SE, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 61 (Engine System-General Information -- F250-F550 Super Duty (Gasoline)) >> General Procedures >> Connecting Rod Large End Bore

Connecting Rod Large End Bore

WARNING: This page is about a different car, the 2005 Ford Pickup, 2005 Ford F550 Super Duty, 2005 Ford F450 Super Duty, and 2005 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Tighten the bolts to specification, then measure the bore in 2 directions. The difference is the connecting rod bore out-of-round. Verify the out-of-round is within specification.
    • Refer to the appropriate article for the procedure.
    • If out of specification, install new components as necessary. Refer to the appropriate article for the procedure.
      Fig 1: Measuring Connecting Rod Large End Bore
      G03946845Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals