Removal and Installation
WARNING: This page is about a different car, the 2006 Mercury Milan, 2006 Lincoln Zephyr, and 2006 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
- With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
- If equipped, remove the 7 screws and the underbody cover.
- Disconnect the crankshaft position (CKP) sensor electrical connector.
- Remove the bolt and the CKP.
- To install, tighten to 10 Nm (89 lb-in).
- To install, reverse the removal procedure.
NOTE:
Lubricate the CKP O-ring seal with clean engine oil.