LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2006 >> Focus ZX5 SE, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 600 (Engine Cooling) >> Removal And Installation >> Block Heater >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2006 Mercury Milan, 2006 Lincoln Zephyr, and 2006 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.

    All vehicles 

  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
  2. Drain the cooling system. For additional information, refer to COOLING SYSTEM DRAINING, FILLING AND BLEEDING .
    3. CAUTION: Make sure that the block heater wiring is routed and secured away from rotating or hot components, or damage to the wiring can occur.
  3. Disconnect the block heater electrical connector.

    4. 2.3L only 

  4. Remove the block heater.
    • To install, tighten to 21 Nm (15 lb-ft).

    5. 3.0L only 

  5. Remove the block heater.
    • To install, tighten to 41 Nm (30 lb-ft).

    6. All vehicles 

  6. To install, reverse the removal procedure.
  7. Fill and bleed the cooling system. For additional information, refer to COOLING SYSTEM DRAINING, FILLING AND BLEEDING .
scientia non olet · About LEMON Manuals