LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2006 >> Focus ZX5 SE, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 582 (Anti-Theft System - Perimeter) >> Removal And Installation >> Door Disarm Switch >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2006 Mercury Montego, 2006 Ford Freestyle, and 2006 Ford Five Hundred. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the battery. For additional information, refer to BATTERY DISCONNECT .
  2. Remove the door trim panel. For additional information, refer to REMOVAL AND INSTALLATION .
  3. Position the watershield aside.
  4. Disconnect the latch lever from the door lock cylinder.
    1. Remove the E-clip.
    2. Disconnect the latch lever.
    Fig 1: Identifying E-Clip & Latch Lever
    G04658430Courtesy of FORD MOTOR CO.
    5. NOTE: The driver door disarm switch can be installed in more than one position. Before removing the switch from the lock cylinder it may be necessary to mark the position of the switch in relation to the door lock cylinder.
  5. Remove the driver door disarm switch.
    • Disconnect electrical connector.
    6. NOTE: The driver door disarm switch can be installed in more than one position. Use the reference marks applied in the removal procedure to index the new driver door disarm switch to the door lock cylinder.
  6. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals