Recalling a Stored Memory Seat Position

WARNING: This page is about a different car, the 2006 Mercury Montego, 2006 Ford Freestyle, and 2006 Ford Five Hundred. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: A memory recall can be initiated only if the vehicle is in PARK or NEUTRAL gear and the ignition switch is not in START. A memory recall in progress will not be affected by moving the ignition switch to START or by moving the gearshift lever out of PARK or NEUTRAL.

Once the driver has stored the driver seat position, the driver can recall the setting by depressing the corresponding memory switch or by using a programmed remote entry transmitter.

The driver can recall the desired driver seat position by depressing one of the memory recall switches. Depressing memory switch 1 will initiate a recall of the power driver seat position stored in memory 1. Depressing memory switch 2 will initiate a recall of the power driver seat position stored in memory 2.

A remote entry transmitter can be used to recall previously set memory positions. The transmitter that has been assigned with personality 1 is capable of recalling memory position 1 only. Similarly, the personality 2 transmitter can recall only memory position 2.

Memory recall occurs when the UNLOCK switch is depressed on the remote entry transmitter. The second depression of the UNLOCK switch, which unlocks passenger doors, does not initiate a memory recall.

A memory recall in progress does not prohibit the initiation of another memory recall; the most recently requested memory recall will be executed.

Memory positions that have not been programmed will not initiate any motion for the power driver seat, power memory rear view mirrors or adjustable pedals.