LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2006 >> Focus ZX5 SE, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 561 (Engine Ignition) >> Removal And Installation >> Ignition Coil-On-Plug >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2006 Mercury Montego, 2006 Ford Freestyle, and 2006 Ford Five Hundred. However, it is still accessible from the selected car via links, so may be relevant.

    RH ignition coils 

  1. Remove the upper intake manifold. For additional information, refer to REMOVAL .

    2. All ignition coils 

  2. Disconnect the ignition coil electrical connectors.
  3. Remove the ignition coil bolts.
    • To install, tighten to 6 Nm (53 lb-in).
    4. NOTE: When removing the ignition coils, a slight twisting motion will break the seal and ease removal.
  4. Remove the ignition coils.
  5. To install, reverse the removal procedure.
    • Apply a light film of Silicone Brake Caliper Grease and Dielectric Compound XG-3-A meeting Ford specifications ESE-M1C171-A to the inside of the coil boots before installation.
scientia non olet · About LEMON Manuals