LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2006 >> Focus ZX5 SE, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 555 (Exterior Trim And Ornamentation) >> Removal And Installation >> Rocker Panel Molding >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2006 Mercury Montego, 2006 Ford Freestyle, and 2006 Ford Five Hundred. However, it is still accessible from the selected car via links, so may be relevant.
  1. Open the front and rear door.
  2. Position the lower door side portion of the fender molding away from the fender.
  3. Release the lower rocker panel molding retainers from the body, starting from the front of the vehicle moving rearward.
  4. Release the upper rocker panel molding retainers from the body, starting from the front of the vehicle moving rearward.
  5. Remove the rocker panel molding.
  6. To install, reverse the removal procedure.
    • It is necessary to install new rocker panel molding retainer clips anytime the rocker panel molding is serviced.
scientia non olet · About LEMON Manuals