LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2006 >> Focus ZX5 SE, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 547 (MULTIFUNCTION Electronic Modules System) >> Removal And Installation >> Smart Junction Box (SJB) >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2006 Mercury Montego, 2006 Ford Freestyle, and 2006 Ford Five Hundred. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
  • If the SJB is dropped, damage to the internal components may occur. A new SJB must be installed.
  • Prior to the removal of the module, it is necessary to upload module configuration information to the appropriate diagnostic equipment. This information needs to be downloaded into the new module once installed. For additional information, refer to PROGRAMMABLE MODULE INSTALLATION .
  • Electronic modules are sensitive to static electrical charges. If exposed to these charges, damage may result.
  1. Disconnect the battery. For additional information, refer to BATTERY DISCONNECT .
  2. Remove the steering column cover. For additional information, refer to REMOVAL AND INSTALLATION .
  3. Disconnect the SJB electrical connectors.
  4. Remove the 3 nuts and the SJB.
    • To install, tighten to 3 Nm (27 lb-in).
  5. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals