LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2006 >> Focus ZX5 SE, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 546 (Instrument Cluster System) >> Diagnosis And Testing >> Instrument Cluster >> Instrument Cluster Diagnostic Trouble Code (DTC) Index

Instrument Cluster Diagnostic Trouble Code (DTC) Index

WARNING: This page is about a different car, the 2006 Mercury Montego, 2006 Ford Freestyle, and 2006 Ford Five Hundred. However, it is still accessible from the selected car via links, so may be relevant.
INSTRUMENT CLUSTER DIAGNOSTIC TROUBLE CODE (DTC) INDEX

DTC Description Source Action
B1202 Fuel Sender Circuit Open (sender with fuel pump module) GO to PINPOINT TEST B . -
B1204 Fuel Sender Circuit Short To Ground (sender with fuel pump module) GO to PINPOINT TEST B . -
B1205 Instrument Cluster Switch Number 1 Assembly Circuit Failure Instrument Cluster REFER to INFORMATION AND MESSAGE CENTER .
B1317 Battery Voltage High Instrument Cluster GO to PINPOINT TEST H .
B1318 Battery Voltage Low Instrument Cluster GO to PINPOINT TEST H .
B1342 ECU is Defective Instrument Cluster INSTALL a new instrument cluster. REFER to INSTRUMENT CLUSTER . TEST the system for normal operation.
B1868 Lamp Air Bag Warning Indicator Circuit Failure Instrument Cluster INSTALL as new instrument cluster. REFER to INSTRUMENT CLUSTER . TEST the system for normal operation.
B1870 Lamp Air Bag Warning Indicator Circuit Short to Battery Instrument Cluster INSTALL as new instrument cluster. REFER to INSTRUMENT CLUSTER . TEST the system for normal operation.
B2143 NVM Memory Failure Instrument Cluster CLEAR the DTCs. REPEAT the self-test. If DTC B2143 is still present, INSTALL a new instrument cluster. REFER to INSTRUMENT CLUSTER .
B2477 Module Configuration Error Instrument Cluster REFER to MODULE CONFIGURATION .
B2627 Fuel Sender Circuit Open #2 (secondary fuel sender) GO to PINPOINT TEST B . -
B2628 Fuel Sender Circuit Short To Ground #2 (secondary fuel sender) GO to PINPOINT TEST B . -
B2675 Trip Reset Button Stuck VERIFY that the instrument cluster bezel is aligned correctly and the SELECT/RESET button is not binding. REPAIR as necessary. If the switch is not binding, INSTALL a new instrument cluster. REFER to INSTRUMENT CLUSTER . TEST the system for normal operation. -
B2879 Fuel Tank Jet Pump Fault GO to PINPOINT TEST B . -
All Other DTCs - Instrument Cluster REFER to MULTIFUNCTION ELECTRONIC MODULES .