Window Glass - Liftgate: Removal

WARNING: This page is about a different car, the 2006 Mercury Montego, 2006 Ford Freestyle, and 2006 Ford Five Hundred. However, it is still accessible from the selected car via links, so may be relevant.

WARNING: To prevent glass splinters from entering eyes or cutting hands, wear safety glasses and heavy gloves when cutting glass from the vehicle.

Remove the rear window wiper arm and motor. For additional information, refer to REMOVAL AND INSTALLATION .
Remove the liftgate trim panel. For additional information, refer to REMOVAL AND INSTALLATION .
Disconnect the 2 rear window defrost electrical connectors.

Fig 1: Locating Rear Window Defrost Electrical Connectors
Courtesy of FORD MOTOR CO.

NOTE: Lubricate the existing urethane adhesive with water to aid the special tool while cutting.

Fig 2: Identifying Special Tool

Courtesy of FORD MOTOR CO.

Using the special tool, cut the adhesive away from the liftgate window glass and remove the liftgate window glass.
Using a soft brush or vacuum, remove any dirt or foreign material from the pinch weld.