LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2006 >> Focus ZX5 SE, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 528 (Window And Glass) >> Removal And Installation >> Door Glass Run and Bracket - Rear >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2006 Mercury Montego, 2006 Ford Freestyle, and 2006 Ford Five Hundred. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the rear door trim panel. For additional information, refer to REMOVAL AND INSTALLATION .
  2. Remove the rear door module. For additional information, refer to WINDOW REGULATOR MOTOR - REAR DOOR .
  3. Lower the rear door window glass into the door.
  4. Remove the scrivet.
    Fig 1: Locating Door Glass Run & Bracket - Rear
    G04658935Courtesy of FORD MOTOR CO.
  5. Remove the rear door glass top run bolt.
    Fig 2: Locating Rear Door Glass Top Run Bolt
    G04658936Courtesy of FORD MOTOR CO.
  6. Remove the rear door glass inner weatherstrip.
  7. Carefully position the glass aside, then remove the rear door glass top run.
  8. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals