LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2006 >> Focus ZX5 SE, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 523 (Engine) >> In-Vehicle Repair >> Crankshaft Pulley >> Removal

Crankshaft Pulley: Removal

WARNING: This page is about a different car, the 2006 Mercury Montego, 2006 Ford Freestyle, and 2006 Ford Five Hundred. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
  2. Remove the accessory drive belt. For additional information, refer to REMOVAL AND INSTALLATION .
  3. Remove the pin-type retainers and the RH fender splash shield.
  4. Use the special tool to hold the crankshaft pulley and remove the crankshaft pulley bolt.
    Fig 1: Removing Crankshaft Pulley Bolt
    G04655629Courtesy of FORD MOTOR CO.
  5. Using the special tool, remove the crankshaft pulley.
Fig 2: Removing Crankshaft Pulley
G04655630Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals