LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2006 >> Focus ZX5 SE, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 520 (Engine Cooling) >> Removal And Installation >> Block Heater >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2006 Mercury Montego, 2006 Ford Freestyle, and 2006 Ford Five Hundred. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
  2. Disconnect the battery ground cable. For additional information, refer to BATTERY DISCONNECT .
  3. Drain the cooling system. For additional information, refer to COOLING SYSTEM DRAINING, FILLING AND BLEEDING .
    4. CAUTION: Make sure that the block heater wiring is routed and secured away from rotating or hot components, or damage to the wiring may occur.
  4. Disconnect the block heater electrical connector and position aside.
  5. Remove the block heater.
    • To install, tighten to 21 N.m (15 lb-ft).
  6. To install, reverse the removal procedure.
  7. Fill and bleed the cooling system. For additional information, refer to COOLING SYSTEM DRAINING, FILLING AND BLEEDING .
scientia non olet · About LEMON Manuals