LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2006 >> Focus ZX5 SE, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 52 (Four-Wheel Drive Systems (ESOF) - F250-F550 Super Duty) >> Removal And Installation >> Hublock >> Removal

Removal And Installation: Hublock: Removal

WARNING: This page is about a different car, the 2005 Ford Pickup, 2005 Ford F550 Super Duty, 2005 Ford F450 Super Duty, and 2005 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

    Dual rear wheel vehicles 

  1. Remove the hub extender nuts and the hub extender.
    Fig 1: Removing Hub Extender Nuts
    G03923815Courtesy of FORD MOTOR CO.

    2. All vehicles 

  2. Loosen the hublock screws one to two turns.
  3. Use a small pry bar around the entire hub flange to release the gasket.
    Fig 2: Removing Hublock Gasket
    G03923816Courtesy of FORD MOTOR CO.
  4. Remove and discard the hublock screws.
    Fig 3: Removing Hublock Screws
    G03923817Courtesy of FORD MOTOR CO.
    5. NOTE: Wiggle the axle shaft while sliding the hublock off of the splines to ease removal.
  5. Use a small pry bar around the entire hub flange and remove the hublock from the wheel hub.
  6. Remove the old gasket material completely and discard the O-ring.
  7. Clean the O-ring seal contact area as necessary to provide a good seal.
scientia non olet · About LEMON Manuals