LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2006 >> Focus ZX5 SE, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 515 (Front Suspension) >> Removal And Installation >> Wheel Studs >> Installation

Wheel Studs: Installation

WARNING: This page is about a different car, the 2006 Mercury Montego, 2006 Ford Freestyle, and 2006 Ford Five Hundred. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the wheel stud in the flange making sure the serrations on the stud line up with the serrations in the flange. Install the washers and a reversed wheel nut.
    2. CAUTION: Do not use power tools to install the wheel stud. Damage to the flange can occur.
    Fig 1: Identifying Wheel Stud
    G04655268Courtesy of FORD MOTOR CO.
  2. Tighten the wheel nut until the stud is seated against the hub flange.
  3. Remove the wheel nut and the washers. Discard the wheel nut.
  4. Install the brake disc. For additional information, refer to INSTALLATION .
scientia non olet · About LEMON Manuals