LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2006 >> Focus ZX5 SE, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 50 (Front Drive Axle/Differential -- F250-F550 Super Duty) >> In-Vehicle Repair >> Axle Shaft Seal >> Installation

Axle Shaft Seal: Installation

WARNING: This page is about a different car, the 2005 Ford Pickup, 2005 Ford F550 Super Duty, 2005 Ford F450 Super Duty, and 2005 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the axle shaft seal.
    Fig 1: Installing Axle Shaft Seal
    G03919098Courtesy of FORD MOTOR CO.
  2. Install the new main seal onto the axle shaft.
    1. Position the main seal onto the axle shaft.
    2. Using the special tools and a hammer, seat the main seal onto the axle shaft.
      Fig 2: Installing Main Seal Onto Axle Shaft
      G03904181Courtesy of FORD MOTOR CO.
  3. Position the axle shaft into the shaft housing.
  4. Using the special tools and a hammer, install the main seal into the wheel knuckle.
    Fig 3: Installing Main Seal Into Wheel Knuckle
    G03919101Courtesy of FORD MOTOR CO.
  5. Install the wheel hub and bearing. For additional information, refer to WHEEL HUB .
scientia non olet · About LEMON Manuals