LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2006 >> Focus ZX5 SE, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 483 (Handles, Locks, Latches And Entry Systems) >> Removal And Installation >> Remote Keyless Entry Keypad >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2006 Ford F550 Super Duty, 2006 Ford F450 Super Duty, and 2006 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the battery. For additional information, refer to BATTERY, MOUNTING AND CABLES .
  2. Remove the front door trim panel. For additional information, refer to INTERIOR TRIM AND ORNAMENTATION .
  3. Position the watershield aside.
  4. Disconnect the remote keyless entry (RKE) keypad electrical connector.
    • Release the harness pin-type retainers.
  5. Remove the retaining clip and the RKE keypad and harness.
  6. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals