LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2006 >> Focus ZX5 SE, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 479 (Electronic Engine Control System - Diesel - F250-F550 6.0L (99P F450/550)) >> Removal And Installation >> Engine Oil Pressure (EOP) Switch >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2006 Ford Pickup, 2006 Ford F550 Super Duty, 2006 Ford F450 Super Duty, and 2006 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
    CAUTION: Make sure the ignition switch is in the OFF position prior to working on the electronic engine controls.
  1. Turn the ignition switch to the OFF position.
  2. Remove the turbocharger inlet tube. For additional information, refer to FUEL CHARGING & CONTROLS - TURBOCHARGER .
  3. Disconnect the engine oil pressure (EOP) sensor electrical connector.
    Fig 1: Locating Engine Oil Pressure Sensor Electrical Connector
    G03887107Courtesy of FORD MOTOR CO.
  4. Remove the EOP sensor.
    • To install, tighten to 12 Nm (9 lb-ft).
      Fig 2: Locating EOP Sensor
      G04649516Courtesy of FORD MOTOR CO.
  5. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals