Removal and Installation
WARNING: This page is about a different car, the 2006 Ford F550 Super Duty, 2006 Ford F450 Super Duty, and 2006 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
The halogen bulb contains gas under pressure. The bulb may shatter if the glass envelope is scratched or if the bulb is dropped. Handle the bulb only by its base. Avoid touching the glass envelope. Failure to follow these instructions may result in damage to the bulb.
NOTE:
The fog lamp bulb should not be removed from the fog lamp until just before a new bulb is installed. Removing the bulb for an extended period of time may affect fog lamp bulb performance. Contaminants may enter the fog lamp where they can settle on the lens and reflector. Never turn on the fog lamps with the bulb removed from the fog lamp.
NOTE:
Make sure the headlamp switch and the ignition switch are in the OFF position.
- If equipped, remove the front license plate frame.
- Disconnect the electrical connector and remove the fog lamp bulb.
- To install, reverse the removal procedure.