LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2006 >> Focus ZX5 SE, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 452 (Windows And Glass -- F250-F550 Super Duty) >> Removal And Installation >> Window Glass - Rear >> Installation

Window Glass - Rear: Installation

WARNING: This page is about a different car, the 2006 Ford Pickup, 2006 Ford F550 Super Duty, 2006 Ford F450 Super Duty, and 2006 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

    All vehicles 

    NOTE: Installation of the rear window requires an assistant to push the rear window glass into the rear window opening from outside the vehicle.
    Fig 1: Installing Weatherstrip To Rear Window
    G04646278
  1. Install the weatherstrip to the rear window.
  2. Install the window installation rope on the cab interior side of the rear window weatherstrip ditch. Tie the window installation rope so that it slightly compresses the cab interior side of the rear window weatherstrip.
    Fig 2: Locating Window Installation Rope On Cab Interior Side Of Rear Window
    G04646279
  3. Lubricate the rear window weatherstrip with soapy water.
  4. Position the rear window in the rear window opening.
    Fig 3: Positioning Rear Window In Rear Window Opening
    G04646280
  5. Using the assistance of another technician outside the cab, seat the rear window glass and weatherstrip in the rear window opening.
    1. Pull the installation rope from the window weatherstrip (technician inside the cab).
    2. Push inward and downward on the rear window glass (technician outside the cab).

    6. Vehicles with power sliding window 

    NOTE: Left side shown, right side similar.
    Fig 4: Installing Left Cable End Into Sliding Window Trough
    G04646281
  6. Install the left cable end into the sliding window trough.
  7. Install the left transition block on the cable end.
    Fig 5: Locating Left Transition Block On Cable End
    G04646282
  8. Install the LH cable swag into the rear sliding window.
    Fig 6: Locating LH Cable Swag Into Rear Sliding Window
    G04646283
    NOTE: The right side must have the trough cover installed after carrying out this step.
  9. Install the left transition block and rubber stop in the rear sliding window trough.
    Fig 7: Locating Rear Sliding Window Trough
    G03925737
  10. Repeat Steps  6 through  9 for the right side.

    11. SuperCab vehicles 

  11. Install the child safety seat tether anchors. For additional information, refer to SAFETY BELT SYSTEM .
  12. Install the rear corner trim panels. For additional information, refer to INTERIOR TRIM AND ORNAMENTATION .

    13. Regular and Crew Cab vehicles 

  13. Install the rear trim panel. For additional information, refer to INTERIOR TRIM AND ORNAMENTATION .
scientia non olet · About LEMON Manuals