LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2006 >> Focus ZX5 SE, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 446 (Exhaust System -- F250-F550 Super Duty) >> Diagnosis And Testing >> Exhaust System >> Pinpoint Test >> Pinpoint Test A: Loss Of Power

Pinpoint Test A: Loss Of Power

WARNING: This page is about a different car, the 2006 Ford Pickup, 2006 Ford F550 Super Duty, 2006 Ford F450 Super Duty, and 2006 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. A1 EXHAUST SYSTEM INSPECTION 
    • Inspect the exhaust system for damage or deterioration. Look for cracks, punctures, leaks, loose connections, dents or unusual bending.
    • Is the exhaust system OK? 

    Yes  : GO to A2.

    No  : REPAIR or INSTALL any damaged or deteriorated exhaust components. TEST the system for normal operation.

  2. A2 BACK PRESSURE TEST 
    • Position the vehicle on a hoist. Refer to JACKING & LIFTING .
    • Remove the muffler and tailpipe assembly. Refer to MUFFLER AND TAILPIPE .
    • Start the engine and gradually increase the engine speed to 2,000 rpm with the transmission in NEUTRAL.
    • Is the restriction gone? 

    Yes  : INSTALL a new muffler and tailpipe assembly.

    No  : GO to A3.

  3. A3 BACK PRESSURE TEST 
    • Remove the catalytic converter assembly. Refer to CATALYTIC CONVERTER - 6.0L DIESEL .
    • Start the engine and gradually increase the engine speed to 2,000 rpm with the transmission in NEUTRAL.
    • Is the restriction gone? 

    Yes  : INSTALL a new catalytic converter assembly.

    No  : No indications of a restriction have been detected. CONDUCT a diagnosis on other suspect systems. CLEAR the DTCs.

scientia non olet · About LEMON Manuals