LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2006 >> Focus ZX5 SE, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 44 (Power Steering System -- F250-F550 Super Duty) >> Removal And Installation >> Power Steering Pump Pulley >> Removal

Power Steering Pump Pulley: Removal

WARNING: This page is about a different car, the 2005 Ford Pickup, 2005 Ford F550 Super Duty, 2005 Ford F450 Super Duty, and 2005 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

    Vehicles with 6.0L engine 

  1. Remove the engine cooling fan. For additional information, refer to COOLING FAN -- 6.0L DIESEL .

    2. All vehicles 

    NOTE: Vehicle with air conditioning shown; vehicles without air conditioning similar.
  2. Rotate the tensioner and remove the accessory drive belt from the power steering pump pulley.
    • For vehicles with air conditioning, rotate the tensioner clockwise.
    • For vehicles without air conditioning, rotate the tensioner counterclockwise.
      Fig 1: Rotating Drive Belt Tensioner Clockwise
      G03888353Courtesy of FORD MOTOR CO.

    3. Vehicles with 5.4L and 6.8L engine 

  3. With the vehicle in NEUTRAL, position it on a hoist. For additional information refer to JACKING AND LIFTING .

    4. All vehicles 

  4. Using the special tool, remove the pulley.
    • Inspect the pulley for paint marks in the web area near the hub. If there are 2 paint marks, discard the pulley. If there is no paint or 1 paint mark, use a paint pencil to mark the web area of the pulley near the hub.
      Fig 2: Removing Pulley
      G03904989Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals