Removal and Installation
WARNING: This page is about a different car, the 2006 Ford Pickup, 2006 Ford F550 Super Duty, 2006 Ford F450 Super Duty, and 2006 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
- With vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
- Drain the cooling system. For additional information, refer to COOLING SYSTEM DRAINING, FILLING AND BLEEDING .
- Disconnect the block heater electrical connector.
- Remove the block heater and discard the O-ring seal.
- To install, tighten to 41 Nm (30 lb-ft).
- Install a new O-ring seal.
- To install, reverse the removal procedure.