Removal and Installation
WARNING: This page is about a different car, the 2006 Mercury Mariner and 2006 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
- With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
- Remove the rear bumper cover. For additional information, refer to BUMPERS .
- Press the retaining tabs and remove the parking aid sensor.
- Disconnect the electrical connector.
- To install, reverse the removal procedure.
NOTE:
The rear bumper cover removal is only necessary for access to the outer parking aid sensors. The inner parking aid sensors do not require rear bumper cover removal for access.