LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2006 >> Focus ZX5 SE, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 410 (Information System And Entertainment Systems) >> Removal And Installation >> Antenna Base >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2006 Mercury Mariner and 2006 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the antenna mast.
    NOTE: Access the antenna cable connection behind the RH cowl side trim panel.
  2. Disconnect the antenna cable from the antenna lead-in cable.
  3. Release the antenna cable grommet from the vehicle body.
  4. Remove the RH fender splash shield. For additional information, refer to FRONT END BODY PANELS .
  5. Remove the antenna base mounting nut (located behind the RH fender) and the antenna base.
    • To install, tighten to 7 Nm (62 lb-in).
  6. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals