LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2006 >> Focus ZX5 SE, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 41 (Clutch System -- F250-F550 Super Duty) >> Removal And Installation >> Pilot Bearing >> Installation

Pilot Bearing: Installation

WARNING: This page is about a different car, the 2005 Ford Pickup, 2005 Ford F550 Super Duty, 2005 Ford F450 Super Duty, and 2005 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

    5.4L and 6.8L engines 

    CAUTION: Never install a used transmission input shaft pilot bearing.
    NOTE: The new transmission input shaft pilot bearing is pregreased and does not require additional lubrication.
    Fig 1: Installing New Input Shaft Pilot Bearing
    G03923343Courtesy of FORD MOTOR CO.
  1. Using a soft-face hammer and the special tool, install the new input shaft pilot bearing.

    2. 6.0L engines 

    CAUTION: Never install a used transmission input shaft pilot bearing.
    NOTE: The new transmission input shaft pilot bearing is pregreased and does not require additional lubrication.
  2. Using a soft-face hammer and a suitable driver, install the new input shaft pilot bearing.
scientia non olet · About LEMON Manuals