Motor Electronics Cooler

WARNING: This page is about a different car, the 2006 Mercury Mariner and 2006 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.

Drain the motor electronics cooling system (MECS). For additional information, refer to MOTOR ELECTRONICS COOLING SYSTEM DRAINING AND FILLING .
Remove the front bumper cover. For additional information, refer to BUMPERS .
Loosen the hose clamp and disconnect the inlet hose.

Fig 1: Locating Hose Clamp And Inlet Hose
Courtesy of FORD MOTOR CO.
Loosen the hose clamp and disconnect the outlet hose.

Fig 2: Locating Hose Clamp And Outlet Hose
Courtesy of FORD MOTOR CO.

NOTE: RH shown, LH similar.

Remove the motor electronics (M/E) cooler bolts.
- To install, tighten to 6 Nm (53 lb-in).
  
  Fig 3: Locating Motor Electronics (M/E) Cooler Bolts
  Courtesy of FORD MOTOR CO.
To install, reverse the removal procedure.