LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2006 >> Focus ZX5 SE, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 381 (Cruise Control System) >> Diagnosis And Testing >> Speed Control >> Pinpoint Tests >> Pinpoint Test C: The Speed Control Does Not Disengage When The Brakes Are Applied >> Normal Operation

Normal Operation

WARNING: This page is about a different car, the 2006 Mercury Mariner and 2006 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.

The speed control actuator sends a voltage reference signal through circuit 511 (LG). The stoplamps provide a ground path that enables speed control operation. When the brake pedal is applied, the voltage goes high and speed control goes into standby mode.

Voltage for the speed control servo clutch (internal to the speed control actuator) is supplied by the SJB to the speed control deactivator switch through circuit 101 (GY/YE). The speed control deactivator switch (closed when the brake pedal is not applied) then routes the voltage to circuit 248 (TN/OG) to the speed control actuator. When the brake pedal is firmly pressed, the speed control deactivator switch opens and voltage is no longer supplied to the speed control servo clutch.

scientia non olet · About LEMON Manuals