Removal and Installation
WARNING: This page is about a different car, the 2006 Mercury Mariner and 2006 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Make sure the headlamp switch and the ignition switch are in the OFF position.
- Remove the front bumper cover. For additional information, refer to BUMPERS .
- Remove the 3 headlamp assembly bolts.
- To install, tighten to 5 N.m (44 lb-in).
- Remove the headlamp assembly nut and the headlamp assembly.
- Disconnect the electrical connectors.
- To install, tighten to 5 N.m (44 lb-in).
- To install, reverse the removal procedure.